Begin by cutting off a 10-in. length of the board and setting it aside. Rip the remaining 38-in. board to 6 in. wide and cut five evenly spaced saw kerfs 5/8 in. deep along one face. Crosscut the slotted board into four 9-in. pieces and glue them into a block, being careful not to slop glue into the saw kerfs (you can clean them out with a knife before the glue dries). Saw a 15-degree angle on one end and screw the plywood piece under the angled end of the block.


You can never have too much storage space and this little bench gives you loads. It’s made from those 2X4s and has a great X leg look. Underneath the seat are crates, which you can also make from your 2X4s, for storing just about anything you need to store. This would be a great outdoor bench for the patio. You can use the crates to store outside toys or even things that you need when you’re grilling out. Best of all, you can build the entire thing, including stain, for around $40 or less.
Drill four 5/8-in.-dia. 1/2-in.-deep holes on the large disc—inside the traced circle—then use 5/8-in. dowel centers to transfer the hole locations to the underside of the small disc. Drill four 1/2-in.-deep holes on the underside of the small disc and a 1/2-in.-deep hole in the center of the top for the dowel handle. Glue in the dowels to join the discs, and glue in the handle. We drilled a wood ball for a handle knob, but a screw-on ceramic knob also provides a comfortable, attractive grip.
There’s a lot of space above the shelf in most closets. Even though it’s a little hard to reach, it’s a great place to store seldom-used items. Make use of this wasted space by adding a second shelf above the existing one. Buy enough closet shelving material to match the length of the existing shelf plus enough for two end supports and middle supports over each bracket. Twelve-inch-wide shelving is available in various lengths and finishes at home centers and lumberyards.
You can simply check out these amazingly genius 60 Easy DIY Wood furniture projects that involve the mind-blowing tips and tricks to get crafty with old wood for some amazing DIY furniture recoveries! The mind-blowing DIY furniture samples given in the collection will also leave a great spell on the wood crafting lovers as they are amazingly creative, super functional and smartly made!
The base starts with a plywood frame constructed much like the extension frames: nails or screws, plus glue. Top off the frame by gluing on 1/4-in. plywood (L). Now you’re ready to wrap the frame with solid wood facing using one of my favorite woodworking shortcuts: Instead of routing the facing, then fussing with mitered corners, glue on the facing before you rout and just form simple 90-degree butt joints at corners. Sand the corners flush and then rout the facing (Photo 2). You’ll get tight, perfect corners—fast.

Build this handy stool in one hour and park it in your closet. You can also use it as a step to reach the high shelf. How to make storage shelves: All you need is a 4 x 4-ft. sheet of 3/4-in. plywood, wood glue and a handful of 8d finish nails. Cut the plywood pieces according to the illustration. Spread wood glue on the joints, then nail them together with 8d finish nails. First nail through the sides into the back. Then nail through the top into the sides and back. Finally, mark the location of the two shelves and nail through the sides into the shelves.
×